Do you have questions about this product?
Get answers from real customers and in-house experts with AnswerBox.
Q:Will this cable work to connect between AT835b (with AA batterey) and Pro10 system ATW-1301 and/or ATW-1311
Q:I have a couple of old AT 853a microphone's that, I would like to connect straight into the Sound board, thus eliminating the battery pack.
A:The power module must stay inline. You may use the AT8538 power module which has a smaller footprint.
Q:Hi, i own an ATM 350 clip on mic. i want to go wireless. Do i need this cable to adapt my ATM350 mic to a body pack system?
A:Please contact our Audio Solutions Department at (330) 686-2600 ext 5000 or at email@example.com for assistance with this.
Q:I have an Audix F-90 Microphone
A:No this will not work. The XLRW adapter cable does not pass power from the transmitter to the microphone. Additionally, even if it did, the power supplied by our UniPak model bodypack transmitters is not phantom power, it is a smaller bias voltage.
Q:Whcih AT microphones will work with this cable?
A:The XLRW is designed to connect Dynamic Microphones or "battery operated/powered" Condenser microphones to Audio-Technica UniPak® Bodypack Transmitters used with select Audio-Technica Wireless Systems. Given that information, there is a vast array of (Audio-Technica) microphones that the XLRW will work with (hundreds, if not thousands of microphones would make the list). Please visit www.audio-technica.com to view these dynamic microphones and battery-powered condenser microphones.
A:The XLRW is features an XLRF connector to locking 4-pin connector for use between a dynamic low-impedance microphone (or battery-operated condenser microphone) and A-T UniPak® body-pack wireless transmitter. 29.5" (0.75 m) cable.
Q:ATW-T310 + XLRW Connecting Cable + MB 3k microphone?
A:Thank you for your inquiry. The MK 3K is a dynamic microphone which means it has very low sensitivity (volume). Try turning up the mic gain on the transmitter. This may help, but I cannot guarantee it will be loud enough.
Q:Do you make a cable that is the opposite of this one on both ends?
A:Thank you for your inquiry. Yes, we have the AT8539 power module that is designed to connect an A-T wirleless microphone that has a 4 pin Hirose connetor to a standard XLR input. The power module will convert the phantom power to the proper bias voltage required by the microphone.
Q:Can this be used with line level output
A:Provided the signal from the mixer is at MICROPHONE level and you are using one of our UniPak model bodypack transmitters, this will work. The XLRW cable routes the incoming signal to the low impedance, mic level circuit side of the transmitter. If the signal from the mixer is at INSTRUMENT or LINE level, use our AT-GcW Instrument Cable instead. This will require a 1/4 inch female jack for the mixer output connector however as the AT-GcW has a 1/4 inch male plug on it, NOT an XLR female plug. The AT-GcW cable routes the incoming signal to the high impedance instrument level circuit side of the transmitter. Use the transmitters input level adjustment to obtain the best signal to noise ratio for the mixer/transmitter interface.
Q:Where can I get a longer cable with these ends
A:Thank you for your inquiry. We do not make a longer cable. This would have to be custom built by someone.