Audio-Technica Menu

ATW-49CB

Active Antenna Combiner Kit


U.S. Two-Year Limited End-User Warranty

*Manufacturer's Suggested Retail Price. Actual selling price may vary; please check with an authorized Audio-Technica dealer.



  • Overview
  • Features
  • Downloads
  • Reviews
  • Q & A

  • Overview

    The Audio-Technica ATW-49CB Active Antenna Combiner Kit includes two Active Antenna Combiners designed for use with Audio-Technica 5000, 4000, 3000 and 2000 Series UHF wireless receivers and ATW-A49 LPDA antennas. Each Active Antenna Combiner is a broadband device (frequency range from 440 to 900 MHz) that combines two incoming RF signals into one outgoing RF signal. One set of Active Antenna Combiners enables two sets of antennas to feed one wireless receiver or distribution system.

  • Features

    • Each kit includes:
      two dual-input, one-output Active Antenna Combiners;
      two 18 BNC-to-BNC RG 58 coaxial antenna cables

    • One set of Active Antenna Combiners enables two sets of antennas to feed one wireless receiver or distribution system

    • Each Active Antenna Combiner is a broadband device (frequency range from 440 to 900 MHz) that combines two incoming RF signals into one outgoing RF signal

    • Designed for use with Audio-Technica 5000, 4000, 3000 and 2000 Series UHF wireless receivers and ATW-A49 LPDA antennas

    • The Active Antenna Combiner provides unity gain to compensate for RF signal loss associated with combining signals

    • Also suitable for use with a variety of other receivers and antennas
  • Downloads

    ATW-49CB Manual (pdf 2.79 M)
    ATW-49CB Submittal Sheet (pdf 105.04 KB)
  • Reviews

  • Q & A

    Can the ATW-49CB antenna combiner be used to combine channels A & B of one receiver to become channel A on a distribution system?

    Gary

    Thank you for your inquiry. No, they cannot be used in that fashion.

    AudioSolutionsManager

    Can I use two of these combiner kits to feed 3 pairs of active antennas into one distribution system?

    Timpitot

    Yes, as long as the distribution system you are using provides enough current to power the combiners and the antennas.

    ATUS_Specialist1

    Will the ATW-49CB work with the 2000 series wireless?

    Sceaziks

    Thank you for your inquiry. Yes, it will work with the current version of the 2000 series (a version) because this version provides antenna power. It will not work with the previous version.

    AudioSolutionsManager

    ATW-49CB Integration Is there any issue with using the ATW-49CB with ATW-A54/64P Antennas along with ATW-DA49 Distribution Systems (to be used with 3000 Series Mic Systems) in a permanent installation? The four antennas will be approx. 75-100' from the equipment rack (to be cabled with low-loss RG-8).

    Stan

    The ATW-49SP* and ATW-49CB* are compatible with the A54P and A64P. However, please read the manual and pay close attention to enabling the Power-Pass-Through. CB = Combiner SP = Splitter

    AudioSolutionsSpec2

    I already have the MCB4 antenna combiner. I was wondering if the ATW-49CB was just for Recievers or can it be used on IEM Transmitters?

    Char

    Thank you for your inquiry. The ATW-49CB cannot be used with the MCB4.

    AudioSolutionsManager