System 10 PRO

Digital Wireless Systems

System 10 PRO

Features

  • Digital 24-bit/48 kHz wireless operation for ultimate sound quality and dependable performance
  • Operates in the 2.4 GHz range – completely free from TV interference
  • Receiver units can be docked in the chassis or mounted remotely (up to 328 feet away) via Ethernet cable for added versatility
  • Up to five chassis (ten receiver units) can be linked and used simultaneously
  • Each receiver unit can be paired with up to 10 transmitters, allowing users to instantly switch between different transmitter configurations
  • Chassis’ System ID Display shows RF signal level, system ID, transmitter battery level, and system link status
  • Automatic frequency selection for seamless, interference-free operation
  • Extremely easy operation with instantaneous channel selection, sync, and setup
  • Three levels of diversity assurance: frequency, time & space
  • Ground-lift switch helps eliminate audible hum caused by ground loops

Specifications

Overall System
Operating Frequencies 2.4 GHz ISM band (2400 to 2483.5 MHz)
Frequency Response 20 Hz to 20 kHz Depending on microphone type
Operating Range 60 m (200') Open range env. with no interfering signals
Total Harmonic Distortion <0.05% typical
Operating Temperature Range 0° C to +40° C (32° F to 104° F) Battery performance may be reduced at very low temperatures
Handheld Transmitter
RF Power Output 10 mW
Spurious Emissions Following federal and national regulations
Battery Type Two 1.5V AA not included
Battery Life >7 hours (alkaline) Depending on battery type and use pattern
Dimensions 254.8 mm (10.03") long, 50.0 mm (1.97") diameter
Net Weight 280 grams (9.9 oz) without batteries
Accessories Included AT8456a Quiet-Flexâ„¢ stand clamp
Body Pack
RF Power Output 10 mW
Battery Life >7 hours (alkaline) Depending on battery type and use pattern
Battery Type Two 1.5V AA not included
Dimensions 70.2 mm (2.76") W x 107.0 mm (4.21") H x 24.9 mm (0.98") D
Input Connections Four-pin Locking Connector Pin 1: GND, Pin 2: INST INPUT, Pin 3: MIC INPUT, Pin 4: DC BIAS +9V
Net Weight 100 grams (3.5 oz) without batteries
Spurious Emissions Following federal and national regulations
Receiver
Receiving System Diversity (frequency/time/space)
Maximum Output Level XLR, balanced: 0 dBV 1/4" (6.3 mm), unbalanced: +6 dBV
Power Supply 100-240V AC (50/60 Hz) to 12V DC 0.5A power supply switched mode external
Operating Temperature Range 40° F (4° C) to 110° F (43° C)
Dimensions 209.8 mm (8.26") W x 44 mm (1.73") H x 169.3 mm (6.67") D
Weight 940 grams (33.2 oz)
Accessories Included AC adapter, Link cable, Rack-mount adapters, Joining plate, Rubber feet
Output Connector Remote Receiver Connector: RJ45 Link Connector: RJ12

Downloads

System 10 PRO Submittal Sheet
System 10 PRO Manual
System 10 PRO Quick Start Guide (ATW-T1006 and ATW-T1007)