AT-OC9XEN
Dual moving coil stereo cartridge with Elliptical nude stylus

AT-OC9XEN

AT-OC9XEN
  • Áttekintés
  • Galéria
  • Features
  • Specifications

Áttekintés

AT-OC9XEN

Dual moving coil stereo cartridge with Elliptical nude stylus
AT-OC9XEN

Features

AT-OC9XEN

The next Generation of the legendary OC9 cartridge series

Since its introduction more than 30 years ago, Audio-Technica’s pioneering moving coil OC9 cartridge series has been prized by demanding vinyl listeners and professional critics alike for its musical transparency, expression of sound and precise construction. Featuring a square shank for accurate stylus alignment and nude diamond for increased fine detail retrieval.

  • Features low mass nude elliptical stylus and aluminium cantilever
  • A neodymium magnet and pure iron yoke provide increased magnetic energy
  • Threaded inserts in the cartridge body enable the cartridge to be mounted on to the headshell or integral tonearm with just two screws – no nuts required 
  • Aluminium body minimizes unwanted vibration for reduced resonance and a superior audio reproduction
  • Pure Copper by Ohno Continuous Casting process (PCOCC) is used for the coils to achieve the purest signal possible

Elliptical Nude Stylus

Elliptical diamond stylus follows the groove modulation with greater precision compared to a conical stylus, offering improved frequency and phase responses whilst reducing distortion.

Easy mounting

Threaded holes in the cartridge body enable the cartridge to be mounted on to the headshell, or integral tonearm, with just two screws M2.6 – no nuts or bolts required.

Aluminium Body

Aluminum body minimizes unwanted vibration for reduced resonance and superior audio reproduction

Made in Japan

Produced in the Audio-Technica Fukui factory in Japan under strict quality control for precise manufacturing.

Specifications

Cartridge & Stylus
Frekvencia átvitel 20 - 30,000 Hz
Csatorna szeparáció 25 dB (1 kHz)
Vertikális követési szög 20 degrees
Vertical Tracking Force 1.8 to 2.2 g (standard 2.0 g)
Tű konstrukció Nude square shank
Ajánlott terhelő impedancia Min 100 Ohms
Tekercs impedancia 12 Ohms (1 kHz)
DC ellenállás 12 Ohms
Tekercs induktancia 25 μH (1 kHz)
Kimeneti feszültség 0.35 mV (at 1 kHz, 5 cm/sec)
Kimeneti csatorna egyensúly 1.5 dB (1 kHz)
Tűforma Elliptical Nude
Tűszár Aluminium pipe
Statikus engedékenység 20 x 10 – 6 cm / dyne
Dinamikus engedékenység 9 x 10 – 6 cm / dyne (100 Hz)
Felfogatás 1/2” centers / Threaded inserts
Hangszedő tömeg 7.6 g
Méretek 17.3 (H) x 16.8 (W) x 25.7 (L) mm
Mellékelt tartozékok 1 non magnetic screw driver
1 brush
2 washers
4 pairs of mounting screws: 5mm, 8mm, 10mm, 12mm
1 plastic protector
Anyaga Aluminium
Modell AT-OC9XEN
Tű méret 0.3 x 0.7 mil
Pin-csatlkozó Brass
Tekercshuzal PCOCC (Copper by Ohno Continuous Casting process.)

Vélemények