AT-OC9XML
Dual moving coil stereo cartridge with Microlinear stylus

AT-OC9XML

AT-OC9XML
  • Áttekintés
  • Galéria
  • Features
  • Specifications

Áttekintés

AT-OC9XML

Dual moving coil stereo cartridge with Microlinear stylus
AT-OC9XML

Features

AT-OC9XML

The next Generation of the legendary OC9 cartridge series

Since its introduction more than 30 years ago, Audio-Technica’s pioneering moving coil OC9 cartridge series has been prized by demanding vinyl listeners and professional critics alike for its musical transparency, expression of sound and precise construction. Microlinear complex diamond profile enabling higher frequency response, detail like never before experienced and limiting inner groove distortion. Microlinear diamond profile provides low record and stylus wear.

  • Features nude Microlinear stylus and boron cantilever which provides lower distortion and high transient response
  • A neodymium magnet and permendur yoke provides dramatically increased magnetic energy
  • Threaded inserts in the cartridge body enable the cartridge to be mounted on to the headshell or integral tonearm with just two screws – no nuts required 
  • Aluminium body minimizes unwanted vibration for reduced resonance and a superior audio reproduction
  • Pure Copper by Ohno Continuous Casting process (PCOCC) is used for the coils to achieve pure signal transfer 

Microlinear Stylus

Microlinear diamond profile offers high frequency response with less wear and distortion than elliptical or conventional linear contact styli.

Easy mounting

Threaded holes in the cartridge body enable the cartridge to be mounted on to the headshell, or integral tonearm, with just two screws M2.6 – no nuts or bolts required.

Aluminium Body

Aluminum body minimizes unwanted vibration for reduced resonance and superior audio reproduction

Made in Japan

Produced in the Audio-Technica Fukui factory in Japan under strict quality control for precise manufacturing.

Specifications

Cartridge & Stylus
Frekvencia átvitel 20 - 47,000 Hz
Csatorna szeparáció 27 dB (1 kHz)
Vertikális követési szög 20 degrees
Vertical Tracking Force 1.8 to 2.2 g (standard 2.0 g)
Tű konstrukció Nude square shank
Ajánlott terhelő impedancia Min 100 Ohms
Tekercs impedancia 12 Ohms (1 kHz)
DC ellenállás 12 Ohms
Tekercs induktancia 25 μH (1 kHz)
Kimeneti feszültség 0.4 mV (at 1 kHz, 5 cm/sec)
Kimeneti csatorna egyensúly 1.0 dB (1 kHz)
Tűforma Microlinear
Tűszár 0.28 mm Ø nude boron
Statikus engedékenység 20 x 10 – 6 cm / dyne
Dinamikus engedékenység 16 x 10 – 6 cm / dyne (100 Hz)
Felfogatás 1/2” centers / Threaded
Hangszedő tömeg 7.6 g
Méretek 17.3 (H) x 16.8 (W) x 25.7 (L) mm
Mellékelt tartozékok 1 non magnetic screw driver
1 brush
2 washers
4 pairs of mounting screws: 5mm, 8mm, 10mm, 12mm
1 plastic protector
Anyaga Aluminium
Modell AT-OC9XML
Tű méret 2.2 x 0.12 mil
Pin-csatlkozó Brass
Tekercshuzal PCOCC (Copper by Ohno Continuous Casting process.)

Vélemények