200 Series Freeway: ATW-201 and ATW-202 systems

Overview

200 Series Freeway: ATW-201 and ATW-202 systems

The 200 Series Wireless Systems have been updated. Click here for information on the newest systems. Audio-Technica’s Freeway 200 Series Wireless System provides proven performance in a variety of settings. Each 200 Series professional VHF wireless system includes a receiver and either a body-pack transmitter or a handheld microphone/transmitter on a specific crystal-controlled frequency. The ATW-R200 receiver design features an innovative docking power supply configuration. An AC power adapter housed in a compartment in the receiver uses an IEC-standard detachable power cordset. Furthering its flexibility, the power adapter may be easily removed from the receiver case, permitting its use as a conventional in-line AC adapter. A novel dipole antenna system on the receiver improves operation by providing a ground element in addition to the usual signal element.

Features

Advanced dipole antenna system
Available in three traveling frequencies
Removable docking power supply inserts into back of receiver
Adjustable squelch control
ATW-T201 UniPak® transmitter includes variable microphone/guitar trim control
ATW-T202 handheld microphone/transmitter features a rugged dynamic unidirectional element

Specifications

Overall System
Operating Frequencies	VHF high band, 169 MHz to 172 MHz
Modulation Mode	FM
Maximum Deviation	±15 kHz
Frequency Response	80 Hz to 13 kHz
Frequency Stability	±0.005%
Operating Range	200' minimum
Operating Temperature Range	40° F (4° C) to 110° F (43° C)
Number Of Channels	Fixed channel

Handheld Transmitter
RF Power Output	10 mW High position, 2 mW Low position, typical
Spurious Emissions	Under federal regulations
Microphone Element	Dynamic unidirectional
Battery Type	9V (NEDA type 1604) alkaline, not included
Battery Life	Approximately 15 hours in High position; Approximately 20 hours in Low position (depending on battery type and use pattern)
Current Consumption	30 mA typical
Dynamic Range	>=90 dB, A-weighted
Dimensions	9.50" (241.3 mm) long, 2.10" (53.3 mm) diameter
Net Weight	12.7 oz (360 g)
Accessories Included	AT8456a Quiet-Flex™ stand clamp

Body Pack
RF Power Output	10 mW High position, 2 mW Low position, typical
Battery Life	Approximately 15 hours in High position; Approximately 20 hours in Low position (depending on battery type and use pattern)
Battery Type	9V (NEDA type 1604) alkaline, not included
Current Consumption	30 mA typical
Dimensions	2.56" (65.0 mm) W x 4.33" (110.0 mm) H x 1.00" (25.4 mm) D
Input Connections	High impedance, low impedance, bias
Net Weight	2.8 oz (78 g)
Spurious Emissions	Under federal regulations
Dynamic Range	>=90 dB, A-weighted

Receiver
Receiving System	Non-diversity, single-channel, dual antenna system
Image Rejection	50 dB minimum
Sensitivity	20 dBµV for 60 dB S/N (IEC-weighted)
Power Supply	120V AC 60 Hz, 6 VA; or 12V DC, 200 mA, center positive, with external DC supply
Operating Temperature Range	40° F (4° C) to 110° F (43° C)
Dimensions	8.27" (210.0 mm) W x 1.72" (43.5 mm) H x 4.73" (120.0 mm) D
Weight	18.9 oz (536 g); without AC adapter, 11.9 oz (336 g)
Accessories Included	AD1202A 120V docking AC adapter; 120V AC IEC cordset
Total Harmonic Distortion	<=1% (10 kHz deviation at 1 kHz)
Audio Output	350 mV (1 kHz modulation, 10 kHz deviation, 100 k ohm load)
Output Connector	1/4" TS ("mono") phone jack

Downloads

200 Series Freeway® Manual (DISCONTINUED: ATW-201 and ATW-202 systems)